loading of welded wire mesh highway fence
We loaded the welded wire mesh fence for highway yesterday. It has better prices comparing with other fence, and it install easily,so it is very popular for highway protecting
This kind of fence includes:
Mesh : 100x150mm, 100x200mm, 150mmx200mm, 150mmx100mm
Wire diameter: 1.8mm-3.5mm
Width: 1.5m-2.2m
Length: 20m-50m each roll
Installation of this fence
Dig the holes on the ground for the post at every 2m, or 2.5m, or 3m, or 5m , the common hole size is 300mm-500mm . depth is 500mm-1000mm. alignment keep them in the line. Every 5-20m , on the left and right of the post, dig two holes for two braces. the hole size same as the post hole size.
After all the holes finished , Put the posts into the hole. Pay attention to controlling hammer force when the post approaching the depth in construction. Then pouring of concrete like this, the brace install in the same way, and the brace connect with bolts:
Dan moet je wachten tot het beton voldoende droog is. Dan kunt u het gelaste gaasscherm samen met de paal plaatsen. Omdat we op de paal de haken hebben gemaakt, moeten we bij het installeren van het draadgaaspaneel de draad op de haak uitlijnen, zodat het draadgaaspaneel stabieler is, hier moeten we de haken plat slaan met de hamer.
Firstly, make one end of the tension wire fixed on the first post with the wire tighterner . Secondly, interval of 15meters, the other end of the tension wire fixed on the post , with the wire tighterner, the wire was straightened. and the wire mesh panel was more stable.
Welcome to contact and send inquiries