Добро пожаловать на наши сайты!

Апр . 23, 2023 18:42 Обратно к списку

Установка дорожных ограждений



  1. Сделайте отверстия для стоек и раскосов.

 

Dig the holes on the ground for the post at every 2m, or 2.5m, or 3m, or 5m , the common hole size is 300mm-500mm . depth is 500mm-1000mm. alignment keep them in the line. Every 5-20m , on the left and right of the post,  dig two holes for two braces. the hole size same as the post hole size.   

 

security concertina razor wire fence companies

 

  1. Установка стоек и раскосов.

After all the holes finished , Put the posts into the hole. Pay attention to controlling hammer force when the post approaching the depth in construction. Then pouring of concrete like this, the brace install in the same way, and the brace connect with bolts:

 

security concertina razor wire fence company

 

  1. Монтаж панели из сварной сетки

Затем необходимо дождаться, пока бетон достаточно высохнет. Затем вы можете установить панель забора из сварной сетки вместе со столбом. Поскольку на столбе мы сделали крючки, при установке панели из проволочной сетки, выравнивание поместите проволоку на крюк, чтобы панель из проволочной сетки была более стабильной, здесь нам нужно ударить по крючкам плоско с помощью молотка.

 

security concertina razor wire fence exporter

 

  1. Установка натяжной проволоки

Firstly, make one end of the tension wire fixed on the first post with the wire tighterner  . Secondly, interval of 15meters, the other end of the tension wire fixed on the post , with the wire tighterner, the wire was straightened. and the wire mesh panel was more stable.

 

security concertina razor wire fence exporters

security concertina razor wire fence factories

Делиться

Если вы заинтересованы в наших продуктах, вы можете оставить свою информацию здесь, и мы свяжемся с вами в ближайшее время.


ru_RURussian