1. Naredite luknjo za stebre in naramnice.

Dig the holes on the ground for the post at every 2m, or 2.5m, or 3m, or 5m , the common hole size is 300mm-500mm . depth is 500mm-1000mm. alignment keep them in the line. Every 5-20m , on the left and right of the post,  dig two holes for two braces. the hole size same as the post hole size.   

2. Namestitev stebrov in opornikov.

After all the holes finished , Put the posts into the hole. Pay attention to controlling hammer force when the post approaching the depth in construction. Then pouring of concrete like this, the brace install in the same way, and the brace connect with bolts:

3. Montaža panelov iz varjene žične mreže

Nato morate počakati, da se beton dovolj posuši. Nato lahko namestite ograjno ploščo iz varjene žične mreže skupaj s stebrom. Ker smo na stebru izdelali kljuke, pri namestitvi plošče iz žične mreže poravnajte žico na kavelj, da bo plošča iz žične mreže bolj stabilna, tukaj moramo s kladivom udariti po kljukah.

4. Namestitev napenjalne žice

Firstly, make one end of the tension wire fixed on the first post with the wire tighterner  . Secondly, interval of 15meters, the other end of the tension wire fixed on the post , with the wire tighterner, the wire was straightened. and the wire mesh panel was more stable.